Jump to content


  • Posts

  • Joined

  • Last visited

Everything posted by jackaustin

  1. I have a number of Panasonic FZ-M1 tablets, all the same spec and SSD partitioning with Windows 8. I built one up and used Full disk Backup to backup and restore on to the remaining tablets. this all worked fine. I gave one of the tablets to my customer so he could configure all his windows security policices etc (he also enabled bitlocker). This tablet was then handed back to me, bitlocker disabled and a full disk backup taken again. However, this time when restoring the Full disk Backup restore, I receive the following error at start up with the BSOD. "A required device isn't connected or can't be accessed. Error code:0xc0000225" I can roll the tablet back to the previous image I have without any problems, but not the new one. I have taken the image twice and used the check image integrity tool and it reports it is fine. I also tried a System backup, which appeared to backup 3 partitions (The tablets have 5 partitions on them), so when I selected System restore, it only allows me to select a single partition to restore back too so this failed. The only other change with the master tablet (which may be significant??), is the BIOS was updated. However, I took an image after this and even tried to restore it to a tablet with the same BIOS, but this still failed. If anybody can offer any suggestions that would be great.
  2. I have a script that resets all permissions on a set of folders and then applies custom permissions. I have another one that set's up auditing on selected folders. For some reason when I run the script that set's up auditing after running the script setting up permissions the permissions on audited folders are set back to default. To audit I run $user = "Everyone" $rules = "Delete,CreateFiles,AppendData" $Inheritance = "ContainerInherit,ObjectInherit" $type = "Success" $ACL = New-Object System.Security.AccessControl.DirectorySecurity $rule = New-Object System.Security.AccessControl.FileSystemAuditRule($user,$rules,$inheritance,"None",$type) $acl.AddAuditRule($rule) foreach($folder in $folders){ $ACL | Set-Acl $folder} auditpol /set /subcategory:"File Share" /success:enable in the script for permissions I have takeown /F c:\test /A /R /D Y icacls c:\test /reset /t /c icacls c:\test /grant:r "NT Authority\Authenticated Users":(CI) (OI) R icacls c:\test\item1 /inheritance:r /grant:r "admin group": (CI) (OI) RWD /grant:r "read group": (CI) (OI) R /grant:r "builtin\Administrators": (OI) (CI) F ..... and more lines in pretty much the same manner for diferent subfolders. Can someone spot where it goes wrong?
  • Create New...